Go to previous page

ELECTRIC WINDOWS

WARNING

Make sure that the smart key is removed when leaving passengers in the vehicle. Doing so prevents unsupervised operation of the windows and sunroof, which may result in injury.

WARNING

Before closing the windows remotely, make sure to have a clear view of the vehicle. Ensure that no children, pets, or obstructions are in any open aperture. Failure to do so may result in injury or death.

CAUTION

Any ice must be removed from the windows before operating. Ice on the window can cause damage to the operating mechanism.

NOTES

Each switch has a two-stage operation. Lightly press or pull and hold the switch to manually operate to the required position. Alternatively, press or pull fully and release for one-touch automatic operation. Automatic operation can be halted, at any time, by operating the switch again.

  1. Window switches:

    Press the front of the switch to partially or fully open.

    Pull the front of the switch to partially or fully close.

    NOTES

    The windows operate for 5 minutes after the engine is switched off, as long as none of the doors are opened.

  2. Rear window isolator and child safety locks. See CHILD SAFETY LOCKS.

    WARNING

    If children are carried in the rear seats, the isolator button should be used to prevent operation of the rear windows. If the windows, rear seats, or doors are operated by young children, there is a risk of serious injury or death.

  3. Sunroof:

    With the sunroof closed, press the rear of the switch to partially or fully raise the sunroof to the tilt position. Press the rear of the switch again to partially/fully open the sunroof.

    NOTES

    If the roof blind is closed, the sunroof switch also opens the roof blind while operating the sunroof.

    With the sunroof open, press the front of the switch to partially or fully close the sunroof.

    CAUTION

    To prevent accidental damage, make sure any roof rack load does not interfere with the opening of the sunroof.

  4. Roof blind:

    Press the rear of the switch to partially or fully open.

    Press the front of the switch to partially or fully close.

    The roof blind can be opened whenever required, but it can only be closed when the sunroof is closed. If the sunroof is partially closed, then the roof blind only partially closes to the same position.

    If the roof blind encounters a resistance when closing, it stops. Then, dependent on its current position, it either partially or fully opens to allow removal of the obstruction. Press and hold the front of the switch, within 10 seconds of the partial or full opening, to override.

  5. Rear screen sunblind:

    Press the switch to deploy.

    Press the switch again to store.

NOTES

If a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25 mm eliminates the condition.