Go to previous page


  1. Parking aid switch. Located next to the Touch screen.

  2. Parking aid sensor detection zones.

  3. 360° PDC (Park Distance Control) sensor detection zones.


Parking aid and 360° PDC sensors do not detect moving objects, such as children and animals, until they are dangerously close. Always use extreme caution when manoeuvring.


The parking aid and 360° PDC sensors may not detect some obstructions, for example, narrow posts or small objects close to the ground. Objects above sensor level may not be detected, for example, when approaching a flatbed truck, the protruding part of the flatbed will not be detected.


If accessories are fitted to the rear of the vehicle, particular care must be taken when reversing. The rear sensors indicate only the distance from the bumper to the obstacle, or accessory if it is detected.


If a trailer is connected to a Jaguar Land Rover approved trailer socket, the rear sensors are disabled.

The parking aid and 360° PDC systems assist the driver while manoeuvring the vehicle in confined spaces. When active, object tracking along the front, side, and rear of the vehicle displays on the Touch screen. The 4 corner sensors provide the 360° PDC monitoring along the vehicle sides. While the vehicle is passing an object that is within sensor range, the vehicle's integrated systems calculate its trajectory within the 360° PDC monitored area.

When objects are detected, the system emits a warning tone, which increases in frequency as the vehicle approaches the object. The tone becomes constant when the object is within 300 mm of the vehicle.

While the vehicle is stationary, the sensors do not detect objects/people approaching from the side. Also, at vehicle start-up, the vehicle has no sensor information about side objects/persons. In both of these situations, ! displays on the Touch screen in these virtual detection zones.

The front, side, and outer rear sensors monitor a 1.2 m area around the vehicle. The inner rear sensors monitor a 1.8 m area at the rear of the vehicle.

The parking aid and 360° PDC system automatically activates when Reverse (R) gear is selected.

While the system is active and a forward gear is subsequently selected, the front and front side sensors remain active until the vehicle’s speed reaches 16 km/h (10 mph), at which point the system disables.


To manually enable the front and side sensors in a forward direction, press the parking aid switch for less than 3 seconds. The LED lamp illuminates to confirm. Press the switch again to disable the temporary use of this setting. The LED lamp extinguishes to confirm.


The parking aid disables if the vehicle's speed exceeds 16 km/h (10 mph).


The sensors must be kept clean to maintain accuracy and performance. See SENSORES Y CÁMARAS.