Go to previous page



Make sure the relevant safety warnings and cautions have been read and understood before operating the parking features. See PARKING FEATURES SAFETY.


If an approved tow bar is fitted, park assist adjusts to compensate for the extra length.

The park assist system is not available if:

  • The vehicle's speed is greater than 18 mph (30 km/h).

  • All Surface Progress Control (ASPC) is active.

  • Reverse (R) is selected.

  • The suspension height is set to off-road.

  • There is a system fault.

  • A trailer is connected.

The park assist system may provide inaccurate results if:

  • The size or shape of the parking space changes after it was measured.

  • There is an irregular curb alongside the parking space, or the curb is covered with leaves, snow, etc.

  • The vehicle is being used to transport a load that extends beyond the perimeter of the vehicle.

  • The sensors are misaligned due to a minor collision or impact.

  • The vehicle had a repair or alteration that was not approved by a retailer/authorized repairer.

  • The vehicle is fitted with non-approved wheels or tires.

  • The vehicle's tire pressures are not set to the vehicle’s recommended specification.

  • The vehicle's tires have significant tire wear.

  • The vehicle is fitted with replacement tires. After the normal breaking-in period, the system adapts to the replacement tires.

  • One of the parked vehicles has an attachment at a raised height such as a flatbed truck, snow plow, or hoist.

  • The parking space is located on a corner or bend.

  • The sensors are dirty or covered in mud, ice, snow, etc.

  • The weather is foggy, raining, snowing, etc.

  • The road surface is uneven or rutted.

  • The vehicle encounters an obstruction that is thin or wedge shaped.

  • The vehicle encounters an obstruction that is elevated and/or protruding, such as ledges or tree branches.

  • The vehicle encounters an obstruction with corners and sharp edges.

  • A non-approved tow bar or trailer hitch is fitted.

  • The sensors are in close proximity to hot exhaust gases from nearby vehicles.

  • The sensors are in close proximity to noise generated from emergency vehicles, motorcycles, etc.

  • The sensors have been damaged during vehicle cleaning.