Go to previous page



During any map update, the USB drive must not be removed, or the vehicle's electrical system switched off, before the update is complete. Doing so cancels the map update and potentially leaves the system without any available map data.


Due to the map data file size, it is recommended that a USB 3.0 memory device is used to update the map data.


The vehicle must be stationary to enable the map update to start. Once the update process has started, the vehicle may be driven.


The navigation system cannot be interacted with until the map update is complete. If a route was active before the map update started, the navigation guidance is limited to voice guidance only.

The map data in the navigation system can be updated using two methods:

  • Downloading the updated map data to a USB memory device. Insert the USB drive into the USB socket. Follow the on-screen instructions within the navigation system to update the maps. Map data can be downloaded from the website: www.jaguar.com/navigation.


    Only the USB sockets in the center console cubby box can be used for map updates. See STORAGE COMPARTMENTS.

  • Online updates are also offered however the vehicle requires an internet connection to enable the feature.

Information on the installed maps is available in the NAVIGATION SETTINGS menu. See SETTINGS.

For further information on navigation system updates, please visit: www.jaguar.com/navigation or contact a retailer/authorized repairer.