Go to previous page

DECLARATION OF CONFORMITY

Export controls:

The product contains commodities, technology, or software exported from the United States (US) in accordance with the Export Administration regulations. Diversion contrary to US or Canadian law is prohibited.

United States of America:

The device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

  1. The device may not cause harmful interference.

  2. The device must accept any interference received, including interference that may cause undesired operation.

NOTES

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

Canada:

The device complies with Industry Canada Standard IC-RSS-210 and IC-RSS-251. Operation is subject to the following two conditions:

  1. The device may not cause interference.

  2. The device must accept any interference, including interference that may cause undesired operation of the device.

The equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment and meets the FCC Radio Frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC Radio Frequency (RF) Exposure rules. The equipment has very low levels of RF energy that is deemed to comply without Maximum Permissive Exposure evaluation (MPE).

But it is desirable that it should be fitted and operated with at least 8 in (20 cm) and more between the radiator and person’s body, excluding extremities: hands, wrists, feet, and ankles.

USA FCC ID: A269ZUA130.

Canada IC: 700BIAM2101.

NOTES

Changes or modifications, not expressly approved by the party responsible for compliance, could void the user’s authority to operate the equipment.

NOTES

The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The equipment limits are designed to provide reasonable protection against harmful interference in a residential fitment.

The equipment generates, uses, and can radiate Radio Frequency (RF) energy. When not fitted and used in accordance with the instructions, the equipment may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular fitment.

If the equipment causes harmful interference to radio or television reception, when turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and the receiver.

  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

  • Consult the retailer/authorized repairer or an experienced radio/TV technician for help.