Go to previous page

WHEEL CHANGING SAFETY

NOTES

If in any doubt regarding the ability to carry out the instructions or comply with warnings, seek assistance.

Make sure to read and fully understand the following warnings. Failure to comply with the safety instructions could result in an accident, leading to serious injury or death.

WARNING

Always find a safe place to stop, off the highway and away from traffic. Switch on the hazard warning lights to alert all traffic of the obstruction. Apply the Electric Parking Brake (EPB) and engage Park (P). Switch the vehicle off and remove the smart key from the vehicle.

WARNING

Make sure that all passengers and animals are out of the vehicle and in a safe place, away from the highway.

WARNING

If available, place a warning triangle at a suitable distance behind the vehicle, facing towards oncoming traffic.

NOTES

Different countries have different traffic laws, where carrying and/or using warning triangles may be required by law when stopping at the side of a highway. The driver is responsible for staying informed about road regulations, and for complying with local traffic laws.

WARNING

In case of an emergency or a breakdown, while working around the vehicle, wear a reflective jacket when stopping at the side of the road.

NOTES

Different countries have different traffic laws, where carrying and/or wearing reflective jackets may be required by law. The driver is responsible for staying informed about road regulations, and for complying with local traffic laws.

WARNING

Disconnect any trailer from the vehicle.

WARNING

Make sure that the vehicle and jack are both on firm, level ground. Do not jack the vehicle if it is over a metal grating or manhole cover.

Make sure that the front wheels are in the straight ahead position and engage the steering lock.

WARNING

Always use the complete jacking lever assembly throughout the wheel changing process, to minimize any chance of accidental injury. Position the jack from the side of the vehicle, in line with the appropriate jacking point. Never place anything between the jack and the ground, or between the jack and the vehicle. Do not attempt to raise the vehicle unless the jack head is fully engaged in the jacking point. Only jack the vehicle using the approved jacking points.

WARNING

WARNING - THAT NO PERSON SHOULD PLACE ANY PORTION OF THEIR BODY UNDER A VEHICLE THAT IS SUPPORTED BY A JACK.

WARNING

The jack is designed for wheel changing only. Never work beneath the vehicle with the jack as the only means of support. Always use correctly-rated vehicle support stands, before putting any body part beneath the vehicle.

WARNING

When jacking the vehicle, make sure that all precautions are taken to prevent vehicle movement. As an additional precaution, it is recommended that the wheels of the vehicle be chocked.

WARNING

Always chock the wheel diagonally opposite the wheel to be changed. Chock the front of a front wheel, or the rear of a rear wheel.

WARNING

If jacking the vehicle on a slight slope is unavoidable, place the chocks on the downhill side of the two opposite wheels. An additional chock is needed.

WARNING

Take care when slackening the lug nuts. The lug wrench may slip off if not properly attached, and the lug nuts may give way suddenly. Either unexpected movement may cause an injury.

WARNING

Do not start or run the vehicle while the vehicle is supported only by a jack.

WARNING

Remove the spare wheel before jacking the vehicle, to avoid destabilizing the vehicle when raised.

WARNING

Take care when lifting the spare wheel and removing the punctured wheel. The wheels are heavy and can cause injuries if not handled correctly.

WARNING

After wheel changing, always secure the tools, jack, and the replaced wheel in their correct storage positions. Such objects, if not properly stored, can become propelled objects in a crash or rollover, potentially causing injury or death.