Go to previous page



The towing point at the rear of the vehicle is designed for on-road recovery only. If it is used for any other purpose, it may result in vehicle damage and serious injury or death.


Use extreme caution when moving or recovering the vehicle. Death or serious injury may occur.

The rear towing points are located behind two small access panels in the rear bumper.

To fit the towing eye:

  1. Press the right edge of the rear bumper's access panel to release the securing clip. Remove the cover.


    Note the orientation of the access cover to aid refitting.

  2. Locate the towing point through the rear bumper. Fully screw the towing eye counter-clockwise into the towing point until secure.


    Pass the vehicle's wheel brace through the towing eye, to act as a lever to help rotate the towing eye until it is completely tight.

To refit the access panel, align the lug into the recess in the bumper. Lightly press the opposite edge to engage the securing clip.