Go to previous page

PROGRAMMING

NOTES

The instructions below apply to the majority of HomeLink® compatible systems. However, there are some HomeLink applications, or HomeLink compatible systems, that require slightly different instructions. For more information and instructional videos, visit: www.HomeLink.com.

NOTES

Garage door openers manufactured after 1995 may be equipped with rolling code protection. In this case, a stepladder, or other sturdy, safe device, may be required to reach the learn or smart button on the garage door opener.

  1. HomeLink buttons.

  2. LED indicator.

  3. Remote control for the device, e.g., garage door.

If required, erase the previous programming from the HomeLink device. See TO ERASE ALL PROGRAMMING.

To program the HomeLink device:

  1. With the vehicle’s electrical system switched on, press and release the HomeLink button (1) chosen to be programmed. The LED indicator (2) flashes orange.

  2. Position the end of the remote control (3) 2 to 8 cm from the HomeLink button.

  3. Press and hold the button on the remote control. Release the button when the LED indicator on the rear-view mirror changes from flashing orange to flashing or solid green.

    NOTES

    Some remote device systems require the operator to cycle the remote control button every 2 seconds during programming. Refer to the additional information in Cycling the remote control at the end of the PROGRAMMING instructions.

  4. Firmly press and release the programmed HomeLink button up to three separate times to activate the device.

The device should now be programmed. If not, carry out the following additional steps:

  1. Locate the learn or smart button on the garage door opener motor-head unit.

    NOTES

    The learn or smart button can usually be found directly on the motor-head unit. If in doubt, refer to the garage door opener manual to identify the button.

  2. Firmly press and release the learn or smart button. There are typically 30 seconds to initiate Step 7.

  3. Return to the vehicle. Firmly press and release the programmed HomeLink button up to three separate times to activate the device. If the device activates, programming is complete.

Cycling the remote control:

Some remote device systems have a remote control signal that only operates for a short period of time. The signal times-out before programming is complete. The operator is required to cycle the remote control button every 2 seconds during programming.

If experiencing difficulties while programming the remote device, carry out the following:

During programming of the remote device, replace programming step 3 with the following:

  1. Press and release the HomeLink button. Simultaneously, press and release the remote control button every 2 seconds, until the LED indicator rapidly flashes green or continuously illuminates green. Release the HomeLink and remote control buttons.

  2. Continue the programming process from step 4.

If the HomeLink LED indicator does not rapidly flash green or continuously illuminate green after performing these steps, contact HomeLink at: www.HomeLink.com.

HomeLink is a registered trademark of Gentex Corporation.