Go to previous page

BESCHRÄNKUNGEN DES EINPARKASSISTENTEN

WARNING

Park assist is a supplement to, and not a replacement for, good observation and a safe driving style. The responsibility remains the driver's at all times, to make sure that reversing manoeuvres are carried out safely.

CAUTION

When washing the vehicle, do not aim high pressure water jets directly at any of the sensors. Do not use abrasive materials, or hard or sharp objects, to clean the sensors. Only use approved vehicle shampoo.

NOTES

When an approved tow bar is fitted, park assist adjusts to compensate for the extra length.

The park assist system is not available when:

  • The vehicle speed is greater than 30 km/h (18 mph).

  • Park (P) is selected on vehicles with an automatic transmission.

  • All Surface Progress Control (ASPC) is on.

  • Reverse (R) is selected on vehicles with both manual and automatic transmissions.

  • There is a system fault.

  • A trailer is connected.

The park assist system may provide inaccurate results if:

  • The size or shape of the parking space changes after it was measured.

  • There is an irregular kerb alongside the parking space, or the kerb is covered with leaves, snow, etc.

  • The vehicle is being used to transport a load that extends beyond the perimeter of the vehicle.

  • The sensors are misaligned due to a minor collision or impact.

  • The vehicle had a repair or alteration that was not approved by a retailer/authorised repairer.

  • The vehicle is fitted with non-approved wheels or tyres.

  • The vehicle is fitted with replacement tyres. After the normal running in period, the system adapts to the replacement tyres.

  • One of the parked vehicles has an attachment at a raised height such as a flatbed truck, snow plough, or cherry picker.

  • The parking space is located on a corner or bend.

  • The sensors are dirty or covered in mud, ice, or snow, etc.

  • The weather is foggy, raining, or snowing, etc.

  • The road surface is uneven or rutted.

  • The vehicle encounters an obstruction that is thin or wedge shaped.

  • The vehicle encounters an obstruction that is elevated and/or protruding, such as ledges or tree branches.

  • The vehicle encounters an obstruction with corners and sharp edges.

  • A tow bar or trailer hitch non-approved is fitted.

  • The sensors are in close proximity to hot exhaust gasses from nearby vehicles.

  • The sensors have been damaged during vehicle cleaning.