Go to previous page

BLIND SPOT MONITOR SENSORS

NOTES

Blind spot monitor messages are displayed on the touchscreen or in the instrument panel.

The blind spot monitor system automatically disables if either of the sensors become completely obscured. The door mirrors display the system disabled warning indicator. See BLIND SPOT MONITOR.

The touchscreen or instrument panel displays the warning message Blind spot monitor sensor blocked.

NOTES

Blockage testing initiates only when the vehicle's speed is above 10 km/h (6 mph). Testing takes at least 2 minutes of accumulated travelling above this speed, to determine that the sensor is blocked.

If the sensors become blocked, check that there is nothing obscuring the rear bumper and that it is clear from ice, frost, and dirt.

If a fault with a radar sensor is detected, the door mirrors display the system disabled warning indicator. See BLIND SPOT MONITOR.

The touchscreen or instrument panel displays the warning message Blind spot monitor not available.

NOTES

If the detected fault affects the radar sensor on only one side of the vehicle, the whole system is disabled. If the fault is temporary, the system operates correctly once the engine has been switched off and then on again.

If a fault in the system occurs, consult a retailer/authorised repairer.