Go to previous page

AUSTAUSCH DER GLÜHLAMPE DES TAGFAHRLICHTS (DRL) – HALOGENSCHEINWERFER

CAUTION
Air cleaner removal :

The air cleaner has to be removed to allow access to the left-side Daytime Running Light (DRL) bulb holder and bulb unit on all engine variants. The air cleaner also has to be removed to allow access to the right-side DRL bulb holder and bulb unit for vehicles with a 3.0L engine.

Open the bonnet and follow the procedure below:

  1. Lightly pull the coolant pipe and/or securing lug to release it from the air cleaner.

    CAUTION

    Do not use excessive force, as this may damage the coolant pipe.

  2. Continually turn the air pipe clamp bolt counter-clockwise to loosen and release.

    NOTES

    Do not remove the air pipe clamp.

  3. Press up and hold the lug at the base of the electrical connector, and then lightly pull to release it from the air cleaner.

  4. Continually turn the securing bolt on the air cleaner counter-clockwise to remove.

  5. Lightly pull the upper air pipe to release it from the air cleaner.

  6. Lightly pull the lower air pipe to release it from the air cleaner.

  7. Lift up the air cleaner casing to release the two securing lugs.

    NOTES

    If the rubber grommets remain attached to the air cleaner, remove them. Refit to the vehicle's body before refitting the air cleaner.

  8. Remove the air cleaner from the vehicle.

    CAUTION

    Observe the position of the coolant pipe, wiring loom, and both air pipes during removal and refitting of the air cleaner.

Reverse the removal procedure to refit the air cleaner.

Daytime Running Light (DRL) bulb removal:

Open the bonnet and follow the procedure below:

  1. Rotate the appropriate headlight cover approximately 45 degrees counter-clockwise to release it. Lightly pull the cover to remove it from the headlight.

    NOTES

    Note the orientation of the cover to aid refitting.

  2. Locate the DRL bulb holder.

  3. Rotate the bulb holder approximately 45 degrees counter-clockwise.

  4. Pull to remove the bulb holder from the headlight and access the bulb.

    NOTES

    Note the orientation of the bulb holder and/or bulb unit to aid refitting.

Reverse the removal procedure to fit a new bulb.