Go to previous page



Before closing a window, make sure that no occupants have any part of their body in a position where it could be trapped. Even with an anti-trap system, death or serious injury could occur.

Anti-trap protection is designed to stop window movement if an obstruction or resistance is detected. Check the window and its aperture, and remove any obstructions. The override procedure is as follows:

  1. Attempt to close the window. Anti-trap will prevent closure and lower the window.

  2. Within 10 seconds, attempt to raise the window again. Anti-trap will prevent closure and lower the window.

  3. Attempt to close the window for a third time, this time holding the switch in the close position. The window will raise while the switch is held. Hold until closed.


If this procedure fails to remove the blockage, or if the windows do not operate correctly, the window operation may need to be reset. See WINDOW RESET.