Go to previous page


To adjust the rear head restraints:

  1. To raise the head restraint, pull it upward until it clicks and locks into position.

  2. To lower the head restraint, press the button on the stem collar. Simultaneously press down on the head restraint.

  3. Press the button on the side of the head restraint to change the angle. Simultaneously move the head restraint to the required position.


    The rear head restraint must be in the upright position when the seat is occupied.

The rear head restraints can be removed, if required, e.g., to fit larger child seats.


Two people are required to carry out this operation.

To remove a head restraint, first move it to the fully raised position. Then:

  1. Press the release tag*, located below the stem collar. At the same time, press the button on the other stem collar.

    *To locate the release tag, press down on the seat material in the area shaded on the illustration.

  2. A second person is now required to lift out the head restraint.


    Always store a removed head restraint securely. In the event of an accident, an unsecured object could cause serious injury or death.

To refit a head restraint, make sure it is facing in the correct direction. Insert the stems of the head restraint into the stem collars, and push the head restraint downward until at least the first click.