Go to previous page

ELECTRIC WINDOWS

WARNING

Make sure to remove the smart key when leaving the vehicle. Remove of the smart key prevents unsupervised operation of the windows and sunroof, which may result in an injury.

  1. Window switches:

    NOTES

    Each switch has a two-stage operation. Lightly press/pull and hold to manually operate to the required position. Alternatively, press/pull fully and release for one-touch automatic operation. One-touch automatic operation can be halted at any time, by operating the switch again.

    Press the front of the switch to partially or fully open.

    Pull the front of the switch to partially or fully close.

    NOTES

    The windows operate for 5 minutes after the engine is switched off, as long as none of the doors are opened.

    CAUTION

    Any ice must be removed from the windows before operating.

  2. Rear window isolator button and child safety locks. See CHILD SAFETY LOCKS.

    WARNING

    If children are carried in the rear seats, the isolator switch should be used to prevent operation of the windows. If the windows are operated by young children, there is a risk of serious injury or death.

  3. Sunroof button:

    NOTES

    The front and rear of the switch has a two-stage operation. Lightly press and hold to manually operate to the required position. Alternatively, press fully and release for one-touch automatic operation. One-touch automatic operation can be halted at any time, by pressing the switch again.

    With the sunroof closed, press the rear of the switch to partially or fully raise the sunroof to the tilt position. Press the rear of the switch again to partially/fully open the sunroof.

    NOTES

    If the sunroof blind is closed, the sunroof switch also opens the sunroof blind while operating the sunroof.

    With the sunroof open, press the front of the switch to partially or fully close the sunroof.

    CAUTION

    To prevent accidental damage, make sure any roof rack load does not interfere with the opening of the sunroof.

  4. Roof blind:

    NOTES

    The front and rear of the switch has a two-stage operation. Lightly press and hold to manually operate to the required position. Alternatively, press fully and release for one-touch automatic operation. One-touch automatic operation can be halted at any time, by pressing the switch again.

    Press the rear of the switch to partially or fully open.

    Press the front of the switch to partially or fully close.

    The roof blind can be opened whenever required, but it can only be closed when the sunroof is closed. If the sunroof is partially closed, the roof blind only partially closes to the same position. If the roof blind encounters a resistance when closing, it stops and then, dependent on its current position it either partially or fully opens, to allow removal of the obstruction and to prevent personal injury or damage to the mechanism. Press and hold the front of the switch, within 10 seconds of the partial or full opening, to override.

NOTES

If a resonance or a booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 1 in (25 mm) eliminates the condition.