Go to previous page

FRONT TURN SIGNAL BULB REPLACEMENT

CAUTION

Observe the position of the coolant pipe, wiring loom, and both air pipes during the removal and refitting of the air cleaner. See CHANGING A BULB.

Air cleaner removal:

The air cleaner has to be removed to allow access to the left-side headlight and also for the right-side headlight for vehicles with a 3.0L engine.

Open the hood and follow the procedure below:

  1. Lightly pull the coolant pipe or retaining lug, to release it from the air cleaner.

    NOTES

    Do not use excessive force, as this may damage the coolant pipe.

  2. Continually turn the clamp bolt on the air pipe counter-clockwise to slacken and release.

    NOTES

    Do not remove the air pipe clamp.

  3. Press up and hold the lug at the base of the electrical connection and then lightly pull to release it from the air cleaner.

  4. Continually turn the air cleaner retaining bolt counter-clockwise to remove.

  5. Lightly pull the upper air pipe to release it from the air cleaner.

  6. Lightly pull the lower air pipe away to release it from the air cleaner.

  7. Lift up the air cleaner casing to release the two locating or securing lugs.

    NOTES

    If the rubber grommets remain attached to the air cleaner, remove them and refit to the vehicle's body before refitting the air cleaner.

  8. Remove the air cleaner from the vehicle.

Reverse the removal procedure to refit the air cleaner.

Xenon headlight turn signal bulb:
  1. Rotate the appropriate headlight cover approximately 45 degrees counter-clockwise to release and remove.

    NOTES

    Note the orientation of the cover to aid refitting.

  2. Pull the bulb holder to remove it from the headlight.

    NOTES

    Note the orientation of the bulb holder to aid refitting.

  3. Pull the bulb to remove it from the bulb holder.

    NOTES

    Note the orientation of the bulb to aid refitting.

Reverse the removal procedure to fit a new bulb.