Go to previous page



The towing eye at the front of the vehicle is designed for on-road recovery only. If it is used for any other purpose, it may result in vehicle damage and/or serious injury.


Use extreme caution when moving or towing the vehicle. Death or serious injury may occur.

The towing eye is part of the vehicle's tool kit, located under the luggage compartment floor panel. For vehicles supplied with a spare wheel, see CAMBIO DE UNA RUEDA. For vehicles supplied with a tyre repair system, see KIT DE REPARACIÓN DE NEUMÁTICOS.

The front towing point is located behind a small access panel in the front bumper.

To fit the towing eye:

  1. Press the lower edge of the front bumper access panel to release the securing clip. Remove the cover.


    It is recommended to remove the cover by releasing the tether arrow head in the bumper cover slot prior to using the towing eye.


    Note the orientation of the access cover to aid refitting.

  2. Locate the towing point through the front bumper. Fully screw the towing eye counter-clockwise into the towing point, until secure.


    Pass the vehicle's wheel brace through the towing eye, to act as a lever to help rotate the towing eye until it is completely tight.

To refit the access panel, engage the tether arrow head in the bumper cover slot, align the lug into the recess in the bumper and then lightly press the opposite edge to engage the securing clip.


Use extreme caution when detaching towing equipment. Vehicle movement is possible which can result in serious injury.