Go to previous page

SUSTITUCIÓN DE LAS BOMBILLAS DE LAS LUCES DE CONDUCCIÓN DIURNA (DRL) – FAROS HALÓGENOS

CAUTION

Observe the position of the coolant pipe, wiring loom, and both air pipes during removal and refitting of the air cleaner. See SUSTITUCIÓN DE UNA BOMBILLA.

Air cleaner removal:

The air cleaner has to be removed to allow access to the left-side Daytime Running Lights (DRL) bulb holder and bulb unit on all engine variants. For vehicles with a 3.0L engine, the air cleaner has to be removed to allow access to the right-side unit also.

  1. Lightly pull the coolant pipe securing lug to release it from the air cleaner.

    NOTES

    Do not use excessive force, as this may damage the coolant pipe.

  2. Continually turn the clamp bolt on the air pipe counter-clockwise to loosen and release.

    NOTES

    Do not remove the air pipe clamp.

  3. Press up and hold the lug at the base of the electrical connection, and then lightly pull to release it from the air cleaner.

  4. Continually turn the air cleaner securing bolt counter-clockwise to remove.

  5. Lightly pull the upper air pipe to release it from the air cleaner.

  6. Lightly pull the lower air pipe to release it from the air cleaner.

  7. Lift up the air cleaner casing to release the two locating and securing lugs.

    NOTES

    If the rubber grommets remain attached to the air cleaner, remove them. Refit to the vehicle's body before refitting the air cleaner.

  8. Remove the air cleaner from the vehicle.

Reverse the removal procedure to refit the air cleaner.

Daytime Running Lights (DRL) bulb removal:
  1. Rotate the appropriate headlight cover approximately 45 degrees counter-clockwise to release. Lightly pull to remove it from the headlight.

    NOTES

    Note the orientation of the cover to aid refitting.

  2. Locate the Daytime Running Lights (DRL) bulb holder.

  3. Rotate the bulb holder approximately 45 degrees counter-clockwise.

  4. Pull to remove the bulb holder from the headlight and to access the bulb.

    NOTES

    Note the orientation of the bulb holder and bulb unit to aid refitting.

Reverse the removal procedure to fit a new bulb.