Go to previous page

ELEVALUNAS ELÉCTRICOS

  1. Window switches:

    NOTES

    Each switch has a 2-stage operation. Lightly press/pull and hold to manually operate to the required position. Alternatively, press/pull fully and release for fully (one-touch) automatic operation. Fully automatic operation can be halted at any time, by operating the switch again.

    Press the front of the switch to partially/fully open.

    Pull the front of the switch to partially/fully close.

    NOTES

    The windows will operate for 5 minutes after the engine is switched off, as long as none of the doors are opened.

    WARNING

    Make sure that the Smart key is removed when leaving passengers in the vehicle. This will prevent unsupervised operation of the windows and sunroof, which may result in injury.

    CAUTION

    Any ice must be removed from the windows before operating.

  2. Rear window isolator.

    WARNING

    If children are carried in the rear seats, the isolator switch should be used to prevent operation of the rear windows.

  3. Sunroof:

    NOTES

    The front and rear of the switch has a 2-stage operation. Lightly press and hold to manually operate to the required position. Alternatively, press fully and release for fully (one-touch) automatic operation. Fully automatic operation can be halted at any time, by pressing the switch again.

    With the sunroof closed, press the rear of the switch to partially/fully raise the sunroof to the tilt position. Press the rear of the switch again to partially/fully open the sunroof.

    NOTES

    If the sunblind is closed, the sunroof switch will also open the sunblind while operating the sunroof.

    With the sunroof open, press the front of the switch to partially/fully close the sunroof.

    CAUTION

    To prevent accidental damage, make sure any roof rack load will not interfere with the opening of the sunroof.

  4. Sunroof blind:

    NOTES

    The front and rear of the switch has a 2-stage operation. Lightly press and hold to manually operate to the required position. Alternatively, press fully and release for fully (one-touch) automatic operation. Fully automatic operation can be halted at any time, by pressing the switch again.

    Press the rear of the switch to partially/fully open.

    Press the front of the switch to partially/fully close.

    The sunroof blind can be opened whenever required, but it can only be closed when the sunroof is closed. If the sunroof is partially closed, then the sunblind will only partially close to the same position.

    If the sunblind encounters a resistance when closing, it will stop and then (dependent on its current position) it will either partially or fully open, to allow removal of the obstruction and to prevent personal injury or damage to the mechanism. Press and hold the front of the switch, within 10 seconds of the partial or full opening, to override.

  5. Rear screen sun blind.

    Press the switch to deploy.

    Press the switch again to stow.

NOTES

If a resonance or a booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.