Go to previous page

NEUMÁTICOS DE REPUESTO

WARNING

Always fit replacement tyres of the same type, and wherever possible, of the same make and tread pattern.

WARNING

The load and speed index ratings on all replacement tyres must be, at least, the same specification as the original equipment supplied by the vehicle manufacturer. If in doubt, consult a Dealer/Authorised Repairer.

WARNING

Do not rotate tyres around the vehicle.

WARNING

If the use of tyres not recommended by the vehicle manufacturer is unavoidable, make sure that you read and fully comply with the tyre manufacturer’s instructions.

WARNING

If lower speed rated specialist tyres are fitted (e.g., winter tyres), then the vehicle must be driven within the speed limitations of the tyres. Consult a Dealer/Authorised Repairer for further information. In markets that require a tyre's maximum speed label to be fitted, the tyre's maximum speed label should be placed within the driver's field of vision. These can be obtained from the tyre dealer.

CAUTION

Make sure that the Tyre Pressure Monitoring System (TPMS) sensor is not damaged during a tyre change.

When the tread has worn down to approximately 2 mm, wear indicators start to appear at the surface of the tread pattern. This produces a continuous band of rubber across the tread, as a visual reminder.

Tyres should be replaced in sets of 4. If this is not possible, replace the tyres in pairs (both front or both rear). When tyres are replaced, the wheels should always be re-balanced and the alignment checked.