Go to previous page

POLTTIMON VAIHTAMINEN

WARNING

If the exterior lamps have just been switched off, give the bulbs time to cool. Handling them when hot may cause personal injury.

WARNING

To avoid personal injury, due to any possible residual electrical current, make sure not to touch any electrical connectors or circuit boards while changing a bulb. If removal of the outboard rear lamp is required, always wear appropriate gloves when disconnecting the wiring loom from the rear lamp.

CAUTION

Always replace bulbs with the correct type and specification. If you are in any doubt, contact a Dealer/Authorised Repairer for advice.

CAUTION

Before attempting a bulb change, make sure that the ignition and the affected lamp are switched off. If the circuit remains live, a short circuit can occur, which may damage the vehicle's electrical system.

Not all bulbs are renewable, for the specification of those which are see POLTTIMOTIEDOT.

All the other lamps should only be renewed or serviced by qualified personnel.

Vehicles with Halogen headlamps will have a removable inboard access cover, as illustrated.

Vehicles with Xenon headlamps will not have a removable inboard access cover. Xenon headlamps have an igniter module, as illustrated.

WARNING

Replacement or maintenance of Xenon lamps should only be carried out by suitably qualified personnel. See KSENONVALOT.