Go to previous page

PROGRAMACIÓN

To program the RF transceiver:

  1. Switch the vehicle’s ignition on.

  2. Position the hand-held transmitter 25 to 75 mm (1 to 3 inches) from the rear-view mirror.

  3. Simultaneously press and hold the memory button on the hand-held transmitter, and the desired memory button on the RF transceiver. An indicator LED, located on the left side of the mirror, will start flashing slowly.

  4. When the LED starts flashing quickly, release both buttons.

To operate the remote device, press and hold the programmed memory button on the RF transceiver for 2 seconds. If the LED illuminates continuously, the RF transceiver has been programmed successfully, and the remote device will operate.

NOTES

You may need to press the button on the RF transceiver up to 3 times.

If the remote device does not operate, and the LED flashes quickly, further programming will be required.

These extra programming steps may require assistance from another person.

  1. Locate the smart/learn program button on the remote device you wish to program.

    NOTES

    The name and location of this button may vary, depending on the manufacturer of the remote device.

  2. Press and release the smart/learn program button and, within 30 seconds, press and hold the desired memory button on the RF transceiver for 2 seconds.

    NOTES

    You may need to press and hold the memory button on the RF transceiver for 2 seconds, a further 2 times.

NOTES

Some entry gate systems require you to cycle (press and re-press) the hand-held transmitter every 2 seconds during programming. If this is the case, continue to press and hold the memory button on the RF transceiver until the LED flashes quickly.

The RF transceiver should now be programmed. Repeat the programming steps, if you wish to add further remote devices to the RF transceiver.

To operate a programmed remote device, press and hold the relevant memory button on the transceiver. Release the button when the device starts operating.