Go to previous page

HALOGEN DIPPED BEAM AND HIGH BEAM BULB

CAUTION
WARNING

To prevent the vehicle from moving and causing personal injury, make sure that the Electric Parking Brake (EPB) is applied.

  1. To allow for greater access, start the engine and turn the steering onto the relevant full lock. Switch off the ignition.

  2. Rotate the vehicle's cover approximately 45 degrees counter-clockwise to release it. Pull to remove the cover.

  3. Rotate the appropriate headlight cover approximately 45 degrees counter-clockwise to release and then pull to remove.

    NOTES

    Note the orientation of the cover to aid refitting.

  4. Rotate the bulb holder approximately 45 degrees counter-clockwise to release it. Pull the bulb holder to remove.

    NOTES

    Note the orientation of the bulb holder to aid refitting.

  5. Release the clips and remove the electrical connector.

    NOTES

    Note the orientation of the bulb to aid refitting.

Reverse the removal procedure to fit a new bulb.

CAUTION

Make sure to straighten the steering system before driving the vehicle.